If you have been considering whether or not to buy a heat pump, then you have lots to benefit from doing so. It can make your house a much comfier place to live, save you money in the long term, and ensure you are more sustainable. However, is it easy to install? To help you get the temperature rising or cooling in your house, we have compiled a starter guide and checklist for installing a new heat pump.
Should You Install a Heat Pump Yourself?
You might think that installing a heat pump will take up too much time — and it can take anywhere between 5 and 6 hours — and you will be better off simply paying someone else to do it. However, this can often be a cost-expensive solution to a simple problem — the typical price ranging between $4,000 and $7,000. You can do it yourself; the important thing is to do a lot of research on your heat pump. This means that you have to do the following.
Identify the Type of Heat Pump That You Need
The first thing to understand is the type of heat pump that you need. They can come in a variety of different shapes of sizes, requiring different approaches. If you aren’t sure what type of heat pump you need, always check with an expert. Once you are sure of what you need, now you need to find a reputable business to buy your pump from. For the lowest prices and plenty of options to choose from, check out thefurnaceoutlet.com.
Once you have your heat pump, take a look on the side of the box that the heat pump came in; from there, you should be able to make that next decision about which kind of approach to take. They often also come with instruction manuals, meaning that you can simply follow the steps that they have provided for you.
Make Sure You Have the Right Toolbox
The saying goes that a bad workman blames his tools. In reality, a bad workman has the wrong tools. Make sure that you have these essential items before you start working:
- Duct Tape
- Drill
- Pliers
- Wire Stripper
- Tubing Bender
- Hammer
- Level
- Saw
- Cable Tie
Figure Out Where You Want to Place It
Location is key. Where you put the pump can depend on the size of your house and the number of units you have. Usually, there will be both an indoor and outdoor unit. We would recommend starting with the outdoor unit first, making sure that it’s properly connected to the wall and any garish sight-lines are covered up. After that, you can move onto the installation step.
Start Installing
After the outdoor unit is secure, you have to set the indoor one, then connect the new air handler to the duct system with sheet metal tools. After that, make use of a hole saw to create a line between the two of them. Once they are connected, run a low voltage wire between them. The crucial part to remember is to connect the condenser to the electrical lines and make sure everything else is firmly fixed in place. If you are unsure of any steps, it’s worth revisiting both the instruction manual as well as the further help of the internet.